How to Install a Carpet Yourself

Carpet installation is not as technically difficult as most homeowners think it is. With the right preparation, it can be a very easy and simple project. The biggest challenge that most people have lies in the size of carpet rolls that they have purchased, and in most cases, the amount of space they have to work with. This is why you should consider handyman Santa Ana in case you need professional help.

The guidelines for laying a carpet are pretty much the same, whether you are laying a plush carpet for your living room or a basement carpet. Other than custom carpets, most carpets are 12 feet wide. Even for a normal room that measures 12 x 12 feet, the rolls will be relatively heavy. In case your carpet must have a seam, make sure you hire an expert to handle the installation. You will get better results than if you tried to install it on your own.

Another instance where you would be better off hiring a professional is if you want to lay a carpet on the stairs. The reason here is mainly for safety and less on aesthetics. An amateur can do handyman Santa Ana CA on the stairs but fail to keep it tight on all the steps. As a result, it the stairs become dangerous because of how easy it will be to trip and fall.

Using a Carpet Pad

For this installation, you must have some adhesive or glue to keep the pad and the carpet glued on the floor. Other than that, you must also keep the carpet properly fixed to the floor around the perimeters. This will help you prevent unnecessary bumps and lumps once you finish laying the carpet.

You must first create a tack strip. The wooden strip should cover the entire perimeter of the space you want to carpet. Nail the strip to your subfloor and keep all the points at an angle to the wall. The points that will be sticking from the tack strip will hold the carpet in place once you have stretched it. Pay attention to the spacing of the tack strips. They are supposed to be set from your wall, a distance that’s the same as the thickness of your carpet.

Set the carpet pad within the layout of the tack strip, and then affix it on the subfloor with staples. You can trim the pad with a small knife if needed. At the point where the duct tape meets the pieces, seal the joints.

Try and lay the carpet in the correct position. The less movement you have when laying out the carpet, the better the results that you will get. You might need a carpet kicker and stretcher to move the carpet above the tack strip spikes with ease. For a handyman Santa Ana expert, these are tools that are very easy to use, out of experience. For a beginner, you might have all the tools needed, but you may still struggle to use them as you should. You will also notice that during installation, professionals have the seams in areas that are not visible or on those that experience less traffic.

Copyright h o m e s t a y b e i j i n g 2 0 0 8 2024