To get a hobby area, a work-top bench or anyplace in your house or garage, it is possible to construct a butcher block counter that is almost indestructible utilizing two-by- . Placing the alongside provides durability, power and moisture resistance that comes when the aspect grain is facing up to the counter. Side grain provides elegance and thickness. Build an old style butcher-block counter and set it up on top of any cupboard to get a counter that will not warp or crack.
Run all the studs down to TO AT LEAST ONE 1/4 inch thick. Use a sander, a planer, or have they are operate by a cabinet store for you personally. This is to eliminate the edges to ensure no gaps are laminated flat, with by them.
Lay the studs flat across two saw-horses. Mix the resin glue with water in line with the directions of the manufacturer’s. Pour the glue.
Run a large bead of glue down the facial skin of all the the studs. So the side of every board is facing the side of the board stand them up on their sides.
Place bar clamps across the studs spaced one foot apart and tighten them somewhat. Using the bar clamps as handles, so the bar clamps are to the underside, flip the stack over. Place bar clamps on leading, involving the bar clamps on the underside. Tighten each of the clamps as difficult as you can with your fingers. Wait 24 hours for the glue to dry.
Remove the clamps. Scrape off all residual glue using a glue scraper. Sand one area having a belt sander -grit belt until easy. Use an orbital sander with 100-grit paper to round each of the edges and sleek the best to eliminate any scratches left over in the belt sander.
Place the two-by-four counter along with a suitable cupboard. Open any doorways or eliminate drawers. Lean to the cabinet using a drill. Using A3/16-inch bit, drill up through along side it jambs, the again rail of the cupboard as well as the again of the faceframe, 1inch down from the most effective edge a-T A – 30-diploma angle so your drill bit penetrates out through the most notable edge of the jambs, top-rail and face-frame. Space the holes 4″ aside. This is known as “toenailing.”
Place 2 inch screws in the holes. Using the gun that is cordless, screw the counter tight to the very top of the cupboard.
Pour A3-inch circle of linseed-oil out along with the counter. Using a delicate fabric, wipe on the oil the the top of counter. Wipe equally sides and the face to get a straight, moist coat of oil. Let it soak in for one hour and wipe off it. Apply oil six months guarded.